ULTIMATE Polish System Bundle

The Ultimate Polish System has been produced using technically advanced formulas to bring you the absolute best four step polishing program for your models.

Below detailed instructions on use : 

Firstly, apply and allow your chosen clear coat to dry for the manufacturers specified time.
Using 6000/8000/12000 grit Micromesh (dependent upon the severity of the flaws in the paint work), lightly sand back/flatten the finish, removing dust and defects as required.
Depending on the result after sanding/flattening, decide whether you need to use #1 Compound or skip to #2 Polish. Deeper scratches/marks will require #1 Compound, while less intrusive marks will only require #2 Polish.

Ultimate Compound #1

Lightly moisten an Ultimate Polishing Cloth with clean water.
Apply a very small amount of Compound #1 to the cloth.
Apply to your model in "crosshatch motions" (straight up and down, then side to side), applying gentle pressure. Be careful of raised areas and paintwork edges so as not to "burn" through the paintwork!
Once applied, remove residue with a clean Ultimate Polishing Cloth.
Remove any excess dried Compound #1 with an old or soft toothbrush.
Repeat from step 1 if required or continue to Ultimate Polish #2 if you're pleased with end result.

Ultimate Polish #2

Lightly moisten an Ultimate Polishing Cloth with clean water.
Apply a very small amount of Polish #2 to the cloth.
Apply to your model in "crosshatch motions" (straight up and down, then side to side), applying gentle pressure. Be careful of raised areas and paintwork edges so as not to "burn" through the paintwork!
Once applied, remove residue with a clean Ultimate Polishing Cloth.
Remove any excess dried Polish #2 with an old or soft toothbrush.
Repeat from step 1 if required or continue to Ultimate Wax #3 if you're pleased with end result.

Ultimate Wax #3

Lightly moisten an Ultimate Polishing Cloth with clean water.
Apply a very small amount of Wax #3 to the cloth.
Apply to your model in a circular motion giving even coverage and applying gentle pressure. Be careful of raised areas and paintwork edges so as not to "burn" through the paintwork!
Once dry, remove residue with a clean Ultimate Polishing Cloth and buff to a high shine.
Remove any excess dried Wax #3 with an old or soft toothbrush.

Ultimate Shine #4

Spray a small amount directly to an Ultimate Polishing Cloth.
Apply to your model in a circular motion giving even coverage and applying gentle pressure.
Once dry, remove residue with a clean Ultimate Polishing Cloth and buff to a high shine.
You can use Shine #4 to give a fresh shine to models as and when required.